Form # 41476-01 Rev. 2-23-2001
Symptom Possible Causes Solution
Troubleshooting
1. No functions operate.
2. Operates only at close range.
3. Inconsistent operation.
Main Power not restored. Replace fuse. Turn ON circuit breaker. Turn ON wall switch.
Transmitter and receiver jumper switches do not match.
Battery too weak.
Set transmitter and receiver to same jumper switch set-
ting.
Replace with new, alkaline battery.
Battery too weak. Replace with new, alkaline battery.
RF interference. Turn OFF wall switch for 5 seconds, then turn back ON.
Continuing RF interference. Change jumper switch settings to a different code in both
Transmitter and Receiver.
© 2001 Hunter Fan Company
Fan High
Fan Medium
Fan Low
Fan OFF
Light Key
Reverse
Figure 5 - Remote Operation
Operating The Remote Control
The hand-held transmitter has individual buttons for control of the light, for
controlling the fan speeds, for turning the fan off, and for reversing. See
Figure 5.
Pressing the “LIGHT” button will turn the light on to full brightness. Hold-
ing the button will cause the light to dim slowly—release the button at the
desired brightness to hold the selected brightness level. Pushing the button
again will turn the light off.
The fan may be started by pressing the HIGH, MEDIUM, or LOW speed
buttons. For best operation, allow the fan to start on HIGH, then select the
desired speed. Press the fan OFF button to turn the ceiling fan off. Press
the REVERSE button to change the fan’s direction while the fan is running.
NOTE: Replace 12-volt battery with type 23 A, MN-21 or equivalent.
You have completed the installation of the integrated remote control. Refer
back to the “Installing Light Fixture” section in the Installation / Owner’s
Manual provided with your Hunter fan for proper instructions.
4. Fan will not reverse.
Fan is not running. Select a fan speed button to start fan, then press the
reverse button.
To Previous Page
Loading...
