Hunter Ellipse 90064 - Existing Construction: Accessible Only from Below - Final Assembly; Motor Wiring and Reinstallation; Securing Motor and Power On

41722-01 09/09/2011
17
•
D18
G
Tighten the wiring cover plate screw.
D17
F
1
2
Install the wiring cover plate. Make sure all
wiring connections are inside the box or under
the wiring cover plate.
D19
H
D20
H
I
D21
D22
Reinstall the motor by inserting the tabs and pushing up into
position. Make sure the wires are not pinched between the
motor and the housing.
Connect wiring from the motor to the wiring cover plate.
Secure the motor by tightening the 2 screws. Turn on the power source.