Step Title
11
42746-01 • 04/26/07 • Hunter® Fan Company
7 • Completing Assembly
Note: Be sure there are no obstructions before lifting
the fan to complete assembly.
7-1. Being careful to not pinch any wires, lift the fan and
upper pole assembly (with assistance from at least
one other person) and place it onto the middle pole
segment. Align the window in the upper pole with the
window in the middle pole.
7-2. Connect the 3-pin plug connector from the fan to the
3-pin plug connector from the base. Push the wires into
the pole.
CAUTION: Do not attempt to assemble fan without all three pole
segments.
Window
Open
Screw
Upper
Pole
Segment
Logo
Coverplate
Screw
Window
Closed
Pole Screw
06549-01-247
(x 1)
Hardware Needed:
Pole Screw
06549-01-247
(x 2)
Hardware Needed:
7-3. Be sure no wires are pinched before
closing the window. Rotate the upper pole
segment 180
o
to align the screw holes and
close the window.
7-4. Align the holes with the logo coverplate
and securely install two screws.
Steps 7-1 - 7-2:
Steps 7-3 - 7-4:
7-5. Install the remaining screw behind the logo coverplate.
Securely tighten all screws.
Step 7-5:
To Next Page
Loading...
Need help?
General
