Hunter Fans - Step 3 - Assembling Pipe;Ball Assembly

10
41557-01 3/12/2002
®
Included with the fan are two pipes:
one 4 1/2" long pipe/ball assembly
for standard mounting and one 2 1/2"
long pipe for flush mounting. See
Figure 3a.
If you are going to install the fan us-
ing the standard mounting, go to
"Step 4 - Assembling the Fan."
If you are going to install the fan us-
ing the flush mounting, complete
the steps below.
REMOVING BALL ASSEMBLY
For the following steps refer to
Figures 3b and 3c.
1. Locate the 4 1/2" pipe/ball as-
sembly.
2. Remove the positioning screw
from the top of the ball.
STEP 3 - ASSEMBLING PIPE/BALL ASSEMBLY
WARNINGS
Figure 3a - Pipes
Figure 3b - Removing ball assembly
NOTE: The ball will become
loose and should slide down the
pipe.
3. Remove the ball from the pipe.
4. Remove the pin from the pipe.
5. Carefully loosen and remove the
ground screw/leadwire assembly
from the pipe.
6. Locate the 2 1/2" pipe.
4 1/2"
Pipe/Ball
Assembly
2 1/2" Pipe
Pin
Positioning Screw
Leadwire
Assembly
Ball
Ground
Screw