Hunter Fans - Step 4 - Assembling the Fan

12
41557-01 3/12/2002
®
STEP 4 - ASSEMBLING THE FAN
1. Insert the pipe through the
canopy as shown in Figure 4. Feed
wires from the fan through the
pipe.
2. Screw pipe into fan assembly un-
til tight. IMPORTANT! Tighten
pipe setscrew as shown in Figure
4.
Figure 4 - Inserting Pipe through Canopy
CAUTION
The pipe has a special coating on
the threads. Do not remove this
coating; the coating prevents the
pipe from unscrewing. Once as-
sembled, do not remove the pipe.
Pipe
Canopy
Pipe
Setscrew