Hunter Fans - Step 8 - Attaching the Switch Housing

18
41557-01 3/12/2002
®
STEP 8 - ATTACHING THE SWITCH HOUSING
The switch housing assembly is made
up of three sections: the switch
housing gasket, the upper switch
housing, and the lower switch
housing/light assembly.
ATTACHING THE SWITCH
HOUSING GASKET
1. Locate the switch housing mount-
ing plate, the switch housing
gasket and the upper plug con-
nector as shown in Figure 8a.
NOTE: Your fan may come with
the switch housing gasket
attached to the switch housing
mounting plate.
If the switch housing gasket is at-
tached to the switch housing mount-
ing plate, go to the section "Attach-
ing the Upper Switch Housing."
If the switch housing gasket is not
attached complete the steps below.
2. Identify the top side of the switch
housing gasket by looking for the
raised circular ridge on the gas-
ket. See Figure 8b.
3. With the top side of the switch
housing gasket facing up towards
the motor, align the holes in the
gasket with the spokes on the
switch housing mounting plate.
4. Feed the upper plug connector
through the center opening of the
upper switch housing. Push the
gasket up so that it is seated flush
with the mounting plate.
See Figure 8c.
Figure 8a - Mounting plate and upper
plug connector Figure 8b - Switch housing gasket
Mounting
Plate
Upper Plug
Connector
Gasket
Align Holes
with Spokes
Feed Upper Plug
Through Center