PROBLEM PROBABLE CAUSE SOLUTION
Noisy operation (continued).
Excessive wobbling.
Note: When switching from medium
to low speed, you may notice some fan
wobble. When the fan stabilizes at low
speed, wobble will disappear.
4. Using non-approved speed control.
5. Switch housing is loose.
1. Unbalanced blades.
2. Loose blades or blade irons.
3. Fan not secure on hanger assem-
bly.
4. Fan hanger ball not seated in
canopy tabs.
4. Change to approved speed control.
5. Check and tighten screws to the
switch housing mounting plate and
to the upper and lower switch
housing.
1. Use balancing kit included with fan.
2. Tighten all screws.
3. Turn power off, support fan very
carefully, loosen canopy and hang
correctly.
4. Turn power off, support the fan very
carefully, and check that the hanger
ball is properly seated.
continued
To Next Page
Loading...
