Hunter Pro-C - Page 11

9
Pro-C Controller
Start Time Stacking…
Prevent hydraulic overload
Preventing hydraulic overload is very
important when designing irrigation sys-
tems, especially residential ones. All elec-
tronic controllers such as the Pro-C allow
the user to input start times into the pro-
grams that could cause the controller to
overlap station run times. This occurs
when the station run times add up to
more minutes than the amount of time pro-
grammed between the start times. In the
Pro-C, the start times will stack and not
begin to actually water until the previous
start time has completed its run through of
all zones programmed. This great feature
will eliminate the possibility of more than
one zone operating at a time, causing the
system to perform poorly when water pres-
sure and ow are minimal.
Multi-language Capability…
User friendly in all parts of the world
The Pro-C line is available as a multi-
language controller family. Separate cus-
tomization kits are available in Spanish
(INT-451), French (INT-452), Italian
(INT-453), and German (INT-454). These
kits include an owner’s operation manual,
door instruction card and a faceplate
overlay that replaces the English version
included with the controller.
PC Programming Option…
Download programs
from a PC
Are you looking for
ways to reduce eld
time at the controller?
Write an irrigation
schedule in your ofce
on your PC using SRP
software version 2.0 or
greater. Download your
program into the Hunter SRP Programmer
tool. Take the SRP tool to the controller,
attach it to the SmartPort
®
connector (fur-
nished with controller) and upload the pro-
gram into the controller. It takes less than a
minute! The SRP Programmer will accept
two independent programs for two differ-
ent applications.
Operate Three 7.2 VA Solenoids
Simultaneously…
Able to accommodate larger water
volume systems
The Pro-C has the power capacity to oper-
ate up to three 7.2 VA solenoids simulta-
neously. There are times when the need
to operate two valve solenoids off of one
station terminal (and one solenoid on the
pump start/MV terminal) is required. This
type of operation may be the result of
reduced watering windows, a retrot with
a city water system switching over to a
water well system, or low volume (drip)
zones added to regular zones. Whatever the
reason may be, the Pro-C can handle it.
Assign Zones to Any or All Programs…
Complete versatility for any watering
requirement
Any station can be assigned to any or all
programs in the Pro-C, making the Pro-C
a truly versatile controller. This feature
allows zones to have more than one water-
ing schedule if required by the landscape.
Automated Chronological Ordering of
Start Times…
No more “phantom” starts!
When more than one start time is entered
into a program, in any order of sequence,
the Pro-C automatically shifts the start
times in ascending order from the earliest
start time to the latest start time. The Pro-C
will also shift or “rubber band” the start