To Next PageTo Next Page
What to do if my Hunter Controller display reads a station number and ERR?
If your Hunter Controller display shows a station number followed by “ERR” (e.g., “2 ERR”), there is a fault in the station solenoid or the station wiring. Check the station wire for continuity, replace or repair any shorted wire, and ensure all wire connections are good and watertight.
Why does my Hunter Pro-C Controller display read “NO AC”?
If your Hunter Controller display reads “NO AC,” it indicates that there is no AC power present, meaning the controller is not receiving power. Check to see if the transformer is properly installed.
General| Start Times Per Program | 4 |
|---|---|
| Warranty | 2 years |
| Cycle + Soak | Yes |
| Display | LCD |
| Housing Material | Plastic |
| Zones | 6, 8, 12, 16 (depending on model) |
| Indoor/Outdoor | Indoor |
| Mounting | Wall-mount |
| Electrical Input | 120V AC, 60Hz |
| Transformer Output | 24V AC |
| Number of Stations | 6, 8, 12, 16 (depending on model) |
| Wireless Capability | No |
