4
WIRELESS RAIN-CLIK
™
COMPONENTS
Wireless Rain-Clik
™
Transmitter
1. Manual Test Spindle – Press and hold
the manual test spindle to confirm proper
operation of your transmitter.
2. Vent Ring – Used to adjust the reset rate
or dry out time for the sensors. Opening
the vents will decrease the reset rate, while
closing the vents will increase the time it
takes for the discs to dry out.
3. Radio Antenna – Transmits a wireless signal
to the receiver up to
800 ft. (275m). It is
recommended that the
antenna be oriented
vertically
4. Mounting Arm – Metal extension arm for
mounting the
sensor.
5. Battery Status
LED – Used to
determine the
status of the sealed
battery. Pushing the manual test spindle will
flash the LED light indicating that the battery
is good.
2
1
Vents
4
3
5
To Next Page
Loading...
Need help?
General
