Hunter SIMPLEconnect - SIMPLEconnect App Setup - Initial Steps; App Installation and Preparation; Controller and PIN Configuration; App Pairing - Controller Selection

www.HunterFan.com
1.888.830.1326
17
M3644-01 • 02/01/17 • © 2017 Hunter Fan Company
Before Getting Started:
If you have not downloaded the app, do so now.
Visit your app store and search simpleconnect then install.
Make sure a compatible receiver is already
installed in your fan. If you need more information, visit the Info
screen in the app.
4
5
6
1
3
2
Record the PIN.
Write down the PIN located on the plug-in controller. You
will need the PIN to complete step 5.
PIN:
Insert the plug-in controller to a wall outlet.
The plug-in controller works up to 80 feet
from the fan/receiver.
Launch the app.
Make sure Bluetooth® is enabled on your device before
launching the app.
Tap the Controller button in the app.
If you are installing multiple plug-in controllers, be sure
to tap the Controller button that coincides with the
correct plug-in control.
Enter the PIN.
The 4-digit PIN can be found on the plug-in controller.
Tap Done when nished.
Tap the Gear icon shown below.
Tap the Gear icon on the main screen to navigate to the
“Rooms Congured” settings screen.
Gear icon