Hunter SIMPLEconnect - SIMPLEconnect App Setup - Pairing; PIN Entry and Room Configuration; Pairing and Power Cycling; Successful Setup Confirmation

www.HunterFan.com
1.888.830.1326
18
M3644-01 • 02/01/17 • © 2017 Hunter Fan Company
7
8
Tap the Gear icon shown below.
For independently operating fans, be sure to choose a
Gear icon for a room that is not already congured.
There is a maximum of four rooms per plug-in controller.
Gear icon
To prevent faulty operation, please disconnect power from all other
ceiling fans within range while performing the next three steps.
Go to Advanced Features. Tap the Pair button.
If your bulbs support dimming, you may also turn
on the dimming feature at this screen.
9
Cycle power to the fan.
Turn power off and back on at the wall (or circuit breaker
if necessary).
Step 10 must be completed WITHIN THREE MINUTES of
restoring power to the fan.
Tap OK to conrm pairing.
Note: The lights will ash (if
applicable) and the fan will turn
on at low speed. This is visual
conrmation that the pairing was
successful.
10
Congratulations!
You have successfully set up your
additional receiver. Tap the Back
button twice to begin using the app
to take control of your fan!
You can now reconnect power to
your other fans.
If you have questions about
using the app or about setup and
installation, visit the Info screen in
the app for FAQs, videos, tutorials,
and more.