21
System Off
Valves currently watering will be
shut off after the dial is turned
to the SYSTEM OFF position for
two seconds. All active programs
are discontinued and watering
is stopped. To return controller
to normal automatic operation,
simply return dial to RUN position.
Manually Run a Single Station
1. Turn dial to the MANUAL-
SINGLE STATION position.
2. Station run time will flash in
the display. Use the
button
to move to the next station.
You may use the
or
button to select the amount of
time for a station to water.
3. Turn the dial clockwise to the RUN position to run the station (only
the designated station will water, then the controller will return to
automatic mode with no change in the previously set program).
Manually Run All Stations
1. Turn dial to MANUAL-ALL
STATIONS
.
2. You can select program A,
B, or C
by pressing the
button.
3. Press the
button until desired
starting station is displayed.
4. Station run time will flash in the display. Use the or buttons
to select the amount of run time for the station to water.
5. Use the button to move to the next station.
6. Repeat steps 3 and 4 to customize each station.
7. Press the
button until you reach the station that you would like
watering to begin.
8. Return dial to RUN (custom program will water, then controller will
return to automatic mode with no change in the previously set program).
NOTE: The station that is on the display when you turn the
dial to RUN will be the first station to run. The controller will
then proceed to water in sequential order only. It will not
water previous stations. Example: If you turn the dial to RUN
with the display reading station 3. The controller will water
stations 3 to 9 in the program, but not return to stations 1 and 2.
To Next Page
Loading...
Need help?
General
