Remote Control Cradle
Option 1: Using Screws
Option 2: Using Adhesive Strip
Install the cradle bracket to the wall with
the included screws.
You have two options to install the included remote control cradle
to the wall. Choose which path works best for you.
Choose your cradle installation location.
If you are installing into drywall, drill two
9/64 width holes using the cradle bracket
as a guide. Gently hammer the included
drywall anchors into the pre-drilled holes.
Press the cradle bracket
against the wall and hold
rmly for 30 seconds.
Slide the cradle onto the
mounted bracket.
Remove the cradle from
the cradle bracket.
Apply the adhesive sticker
to the back of cradle
bracket per the instructions
on the adhesive sticker.
16
To Next Page
Loading...
