Remote Control
To access the battery compartment, remove
the small Phillips head screw that secures the
battery door to the transmitter assembly. The
battery should be installed with the positive
(+) side up. Replace with a CR2032 battery
when necessary.
Phillips
Head
Screw
Battery
Door
ON
Turn Power
The remote transmitter is already paired to the
receiver and ready to use.
Note: If your need to pair your remote, remove the battery
door. Cycle power to the fan by turning power off and back on
at the wall switch (or circuit breaker if necessary). Within three
minutes, press the pair button on the remote. If pairing was
successful, a single beep will sound. If three beeps sound, the
remote was unpaired. Re-pair using the steps above.
To prevent faulty operation, please disconnect power from
all other ceiling fans within range while pairing.
15
To Next Page
Loading...
