TC39 Series Changer Operation Instructions Getting Started •
••
• 11
Use the following tips to prevent this type of tool head damage:
• DO NOT ROTATE while pressing the “Tool Head Raise” button.
• Ensure tool head cradles the rim edge before rotating during demount of
upper bead.
TOOL HEAD NOT CRADLED ON RIM TOOL HEAD CORRECTLY POSITIONED
If the tool head breaks at the mount/demount end the tire bead was not in the drop
center when mounting the upper bead.
Use the following tips to prevent this type of tool head damage:
• The bead MUST be in the drop center when mounting the upper bead.
• Use the bead press device and the upper roller to guide the bead into the
drop center.
• Ensure the bead is completely in the drop center on wheels where the
drop center is far from the bead seat.
BEAD FULLY IN DROP CENTER
Mounting
Bead not drop center.
To Next Page
Loading...
