30 •
••
• Maintenance and Calibration TC39 Series Changer Operation Instructions
Weekly
Clean the tire changer with shop towels or a vacuum
cleaner. Do not clean with or use compressed air,
which can blast dirt between moving parts.
Do not use cleaning solvents to clean pressure
regulator/oiler.
Periodically Refill the pressure regulator/oiler using only Hunter
Lubri-oil as needed. Petroleum-based oils should
never be used in the oiler and may void all
warranties.
Adjust the screw on top of the oiler to release one drop
of oil for every six (6) full up and down cycles of a roller
arm pneumatic cylinder.
Adjust push-pull cables such that the both rollers are
properly adjusted relative to a wheel rim.
Lubricate oil fittings as shown on decal on side of
storage tray.
Check for loose bolts and tighten per specifications.
3.2 Maintenance Replacement Parts
QTY NAME NUMBER
1 Safety Goggles 179-15-2
1 Brush RP6-G108A16
1 Mounting Paste RP6-G800A37
1 Mount/Demount Head RP6-710416960
1 Rubber Protector Pad RP6-710013421
1 2-Head Cone RP6-1157
1 Pin Protector RP6-710090481
1 Pin Extension RP6-710012941
To Next Page
Loading...
