20 •
••
• Basic Procedures TC39 Series Changer Operation Instructions
Raise the mount / demount head until it cradles the rim as shown below.
Verify the bead opposite the mount / demount head drops into the drop center.
TIP: The bead press can be used to push the bead into the drop
center.
Slowly rotate wheel until the entire upper bead is lifted from the rim.
Lift the tire with the mount / demount head. Use your free hand to hold the tire,
opposite the mount / demount head, in the drop center.
Raise the lower roller until the lower bead is slightly above the rim.
Rotate wheel until the entire bead is lifted from the rim.
Remove tire from rim.
To Next Page
Loading...
