11
Factory Reset
Factory Reset
Factory Reset is used to clear all programming out of a WVL
controller, including station assignment, Site ID, and Channel ID.
Procedure:
1. Remove ALL batteries from the WVL.
2. Press and hold the right Assignment button.
3. Continue to hold the button, and insert one battery.
Continue holding the Assignment button for at least 5
seconds until both LED lights turn red.
4. Release the Assignment button immediately. The WVL will
be completely reset.
• If the reset was successful, both LEDs will turn green
momentarily.
• If the reset was not successful, the LEDs will blink red
several times.
Use the app and assignment functions above to add the WVL
back into the system, including station assignment.
Push the battery cap back on rmly, and hand tighten the
retaining ring to complete the installation. Make sure the large
O-rings remain in place to seal the enclosure.
Replace valve box lid with the installed antenna, and verify
proper operation with a controller station start.
+ –
+ –
LED
ASSIGNMENT
BUTTON
To Next Page
Loading...
