Huntleigh D920-P - Page 38

3388
Probe Head Replacement Procedure
Remove any excess grease from the probe
with a dry tissue.
Check that the holes are aligned.
6.
First clean clip recesses at both ends using a
dry tissue, then a cotton bud dipped in
Propanol.
Allow to fully dry.
Nootee: Reepllaacceemeent cclliips must bbee cclleeaaneedd
priioor too aasseembblly usiing Proopaanooll, too reemoovee
aany
eexcceess greeaasee.
7.
In the centre of the first recess, apply adhesive*
as a continuous bead of uniform thickness,
around the whole circumference of the probe.
Apply a bead of adhesive* to the 4 holes, then
fit clips.
8.
Without delay, fit and tighten the tie wrap
around the clips, ensuring that the tie wrap is
centrally located.
9.
Tighten the tie wrap using a tie wrap gun.
Repeat at other end.
10.
The tie wraps can be removed after 5
minutes by sliding them from the probe
body onto the cable, where they can be
cut off.
11.
* Recommended Adhesive :
Loocctiitee 44850