09
6. Assembly and Disassembly of Silicone
※
Silicone packings are consumables that are
recommended to be replaced once every 6 to 12
months. They are available for purchase through the
Customer Service Center.
01
02
03
(The juicer may leak if the product is not assembled
properly.)
Hold and take out the packing as if you are pulling it
back.
After cleaning, insert one side of the packing first as if
you are hooking it.
Insert the remaining part and press down the
perimeter.
After cleaning, insert in a way that the round side of the
packing faces outward while the grid grooves face upward.
Assemble the packing as shown in the figure.
01
02
03
Grab one side and pull it back to detach it.
After cleaning, check the top and bottom of the
packing and insert it as if you are hooking one side.
Firmly press the remaining part of the packing
without any folded area.
Extraction Packing
Seal Packing
Juice Cap Packing
Hopper Packing
After cleaning the silicone brush, pull it from the inside
to the outside to assemble it as shown in the figure.
Grab the top and bottom of the outer blades of the
silicone brush to pull it tightly.
Chamber Packing
Rotating brush packing
01
02
02
01
01
02
To Next Page
Loading...
