STARTING PROCEDURE
15
6
ON OFF
RESERVE
In order to ensure an easy start the
following must be correctly adjusted:
The valve clearances, the idling speed,
the spark plug gap and the mixture
screw of the carburettor.
ATTENTION:
ATTENTION:
Do not drain all of the battery capacity
6
Kick starter models:
Follow the checklist on page 5.
Turn the fuel taps (Fig. 6A-1 & 6B-1) to position
ON (Fig. 6D).
Cold engine: Turn the choke lever (Fig 6A-2) to
position ON (Fig. 6C-1) by pulling it downwards
and twisting it 90° (Fig. 6C-2).
Warm engine: Choke lever should be in OFF
position.
Put the gearshift lever into neutral.
With the throttle fully closed, make a distinct and
long kick all the way through the operational orbit
of the kick start lever. If the engine does not start,
let the kick start lever return all the way back in
order to provide the maximum distance for the
kick start lever and also activating the additional
semi-automatic decompression system.
Cold engine: Warm the engine up (the throttle a
little bit opened) with the choke on until it runs
smoothly.
Engine idling, pull the clutch lever fully towards
the handlebar and engage the 1st gear by
pushing the gearshift lever downwards. Open the
throttle slightly at the same time as you slowly
and gently release the clutch lever.
Shift the gears as soon as adequate rpms have
been achieved.
Electrical starter models:
Follow the checklist on page 5.
Turn the fuel taps (Fig. 6A-1) to position ON (Fig.
6B-1).
Cold engine: Turn the choke lever (Fig 6A-2) to
position ON (Fig. 6B-2) by pulling it downwards
and twisting it 90°.
Warm engine: Choke lever should be in OFF
position.
Put the gearshift lever into neutral.
With the throttle fully closed, push the electrical
start button.
Cold engine: Warm the engine up (the throttle a
little bit opened) with the choke on until it runs
smoothly.
Engine idling, pull the clutch lever fully towards
the handlebar and engage the 1st gear by
pushing the gearshift lever downwards.
Open the throttle slightly at the same time as
you slowly and gently release the clutch lever.
Shift the gears as soon as adequate rpms have
been achieved.
The electrical start models are all equipped with
kick starters. Follow the instructions above: ”Kick
starter models”, if used.
Fig.
6A
Fig.
6B
Fig.
6C
Fig.
6D
To Next Page
Loading...
