Husky HyPET - Auxiliary Equipment

v 2.6 — April 2012 HyPET Injection Molding Machine
2 Auxiliary Equipment
1.4 Auxiliary Equipment
Husky is only responsible for the interaction of Husky equipment and systems with auxiliary
equipment when Husky is the system integrator. If auxiliary equipment is removed, proper
safeguards must be installed.
For information about integrating non-Husky auxiliary equipment, contact your nearest
Husky Regional Service and Sales office.
1.5 Documentation
Each Husky machine is delivered with a Documentation CD that contains a full set of
manuals, drawings, certificates and other documentation needed by operators and service
technicians. Documentation is also available online through www.husky.ca.
Printed manuals and drawings from the Original Equipment Manufacturers (OEMs) are also
provided with the machine when available.
1.5.1 Manuals
Husky manuals aid in the safe and proper use of Husky products. Where applicable, the
manuals provide instructions on installation, operation and maintenance.
Personnel should thoroughly review all manuals provided with their Husky equipment prior
to performing any tasks. Proceed with tasks only if all instructions are understood and always
follow applicable workplace safety requirements.
The following manuals are provided with each Husky machine upon delivery:
IMPORTANT!
If a Husky mold is equipped, refer to the separate Documentation CD provided with the mold
for operation, installation and service information.
IMPORTANT!
Keep all CDs and printed documentation in a convenient location for future reference.
Site Preparation Manual
Describes preparing the site and receiving/handling the machine
Operator Manual
Describes operator controls, startup and shutdown procedures,
production controls, and daily maintenance requirements
Service Manual
Includes specifications and requirements, installation procedures,
scheduled maintenance procedures, corrective maintenance procedures
and troubleshooting