v 2.6 — April 2012 HyPET Injection Molding Machine
10 Noise Hazards
2.3.6 Noise Hazards
When the machine is at idle, the average noise level in the operator’s work area is 85 dB(A),
as measured according to DIN 45 635-T1-Class 2.
The peak noise level will vary depending on processing conditions.
2.3.7 Gas, Vapor and Dust Emissions
Certain processed materials release harmful gas, vapors or dust. Install an exhaust system
according to local codes.
2.3.8 Slip, Trip or Fall Hazards
Do not walk, stand, climb or sit on machine surfaces.
Use an approved platform or walkway around equipment to reach areas that are not
accessible from the floor.
2.3.9 Lifting Hazards
When lifting equipment, use suitable lifting devices, proper balancing techniques and
designated lifting points. Refer to the installation details for handling and lifting instructions.
Do not exceed the rated capacity of the lifting equipment.
2.4 Safety Signs
Safety signs clearly mark potentially hazardous areas in or around equipment. For the safety
of personnel involved in equipment installation, operation and maintenance, use the
following guidelines:
• Verify that all signs are in the proper locations. Refer to the drawing package for details.
• Do not alter signs.
• Keep signs clean and visible.
• Order replacement signs when necessary. Refer to the drawing package for part
numbers.
WARNING!
All personnel in the machine area must wear appropriate hearing protection if noise
emission levels exceed 85 dB(A). Prolonged exposure to excessive noise levels can
cause hearing loss.
Make sure noise levels are in compliance with all applicable local regulations.
To Previous Page
Loading...