Operator Manual v 2.6 — April 2012 Safety Summary
Qualified Personnel 7
Chapter 2 Safety Summary
This chapter describes the general requirements and conditions for safe operation of the
machine.
2.1 Qualified Personnel
Only fully trained and qualified personnel should be permitted to operate equipment.
Qualified personnel must have demonstrated skills and knowledge related to injection
molding equipment, as well as training to recognize potential hazards.
2.2 Safety Guidelines
Personnel operating, installing, maintaining or servicing Husky equipment must adhere to
safe working practices that are in compliance with the following guidelines:
• Use an appropriate ladder or platform to access areas of the machine.
• Lockout and tag electrical, pneumatic and hydraulic energy sources before servicing the
machine or entering the mold area.
• Depressurize the hydraulic system using the manual dump valve before servicing any
hydraulic component.
• Do not climb over Husky equipment while the machine is in operation.
• Do not operate the machine unless all guards are in place.
• Do not operate the machine if a safety interlock is bypassed, modified or damaged.
• Do not operate the machine if any component or system is missing or damaged.
IMPORTANT!
Personnel must read, understand and follow all safety precautions.
IMPORTANT!
Personnel must follow applicable industry and regulatory safety requirements for safe
installation, operation and maintenance of equipment.
To Next Page
Loading...