v 2.6 — April 2012 HyPET Injection Molding Machine
4 Training
1.6 Training
All designated operators and maintenance personnel must be fully trained before using or
servicing Husky injection molding systems.
If training is required, visit www.husky.ca or contact your nearest Husky Regional Service and
Sales office to learn more about Husky’s training solutions.
1.7 Machine Layout
Throughout this manual and other documentation provided with the machine, references
will be made to specific areas of the machine. The illustration below describes these areas
and the standard terminology used to reference them.
IMPORTANT!
The IMPORTANT alert is used to highlight important steps, conditions, or considerations
related to the subject.
IMPORTANT!
It is the obligation of the employer to properly train and instruct all personnel in safe
methods of operation and maintenance. Manuals and other reference material, which have
been prepared by Husky for the operation and maintenance of Husky equipment, do not in
any way absolve the employer from fulfilling these obligations and Husky disclaims liability
for injury to personnel which is attributable to the employer's failure to do so.
To Next Page
Loading...