Chain Lubrication System
Disassembly
Remove oil tank
erly and flush
O
ut
I
filler cap. Dispose of oil prop-
oil tank with solvent. Remove
debris from tank using low pressure air.
Remove clutch cover, chain, bar and clutch
assembly. Remove three screws from oil pump.
Thread two M5 screws into pump housing as
shown. Tighten screws alternately half a turn
each time until pump housing comes loose.
Remove pump housing and M5 screws.
Note: Removal of the oiler also removes
dust cover washer on the crankshaft.
the
Lift oil suction hose and filter from oil tank and
clean or replace oil pick-up filter.
For Husqvarna Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com
To Next Page
Loading...
