3
Safety Equipment
Position punch in clutch cover as shown, and
drive out brake band roll pin. Remove brake
band and knee link assembly.
Check brake band for damage or wear. The
brake band thickness should not be less than
0.75 mm
(.030”) when measured at any point
along the band.
The brake band must be replaced if the band is
damaged or worn less than minimum thick-
ness. If brake band requires replacement,
remove screw and replace band.
6
For Husqvarna Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com
To Next Page
Loading...
