Need help?Do you have a question about the Husqvarna 272K and is the answer not in the manual?
Provides general information about the workshop manual's purpose and scope.
Highlights the importance of reading and understanding safety precautions before performing service.
Mentions the use of special tools and that required tools are listed in the manual.
Emphasizes the need for proper safety equipment and understanding manual contents before repairs.
Details specific safety hazards related to fuel, chain brake, and handling hot components.
Lists tools that are common across all Husqvarna chain saw models.
A comprehensive index of all tools with order numbers and designations.
Provides specific technical data and service specifications for Husqvarna models 36 and 41.
Provides specific technical data and service specifications for Husqvarna models 42, 242 and 246.
Provides specific technical data and service specifications for Husqvarna models 40 and 45.
Provides specific technical data and service specifications for Husqvarna models 51 and 55.
Provides specific technical data and service specifications for Husqvarna models 61, 268 and 272.
Outlines common faults and their probable causes, categorized by engine operation.
Lists potential issues and their causes related to starting the chain saw.
Details common problems related to low-speed idling and their potential causes.
Details dismantling, cleaning, inspection, and assembly of the chain brake mechanism.
Covers dismantling, cleaning, inspection, and assembly procedures for the muffler.
Explains the dismantling and assembly procedures for the throttle lock mechanism.
Provides step-by-step instructions for dismantling the starter unit.
Details the process of assembling the starter unit, including cord and spring installation.
Covers checking, dismantling, and reassembling the ignition module and coil.
Provides detailed steps for dismantling the centrifugal clutch, including model variations.
Details the assembly process for the centrifugal clutch, including shoe and spring fitting.
Covers dismantling the oil pump drive and the oil pump itself for various models.
Provides steps for assembling the oil pump for different Husqvarna saw models.
Describes carburetor operation in different modes: Cold start, Idling, Part throttle, Full throttle.
Covers the process of dismantling the carburetor, including removing plugs and jets.
Details dismantling procedures for specific carburetor models like Tillotson HS 228 B.
Instructions on performing a pressure test on the carburetor and interpreting results.
Covers dismantling the cylinder cover, spark plug, carburetor, muffler, and cylinder.
Details fitting the needle bearing, piston, gudgeon pin, cylinder, and crankcase halves.
Lists parts to remove before splitting the crankcase and describes splitting the crankcase.
Instructions for fitting bearings and seals, including heating crankcase halves.
To Next Page
General
