80 – English
LUBRICATION SYSTEM
Saws 42, 61, 242, 246, 254, 257, 262, 268, 272, 281, 288, 394 and 3120.
1. Lubricate the pinion gear with grease.
2. Fit the oil pump on the saw by
tightening the three bolts.
3. If the tapered sleeve has been used,
remove it.
4. Fit the centrifugal clutch.
See page 69.
5. Fit the bar and chain.
6.
Adjust the oil pump for the correct oil flow.
See the operating instructions.
Saws 61, 268, 272, 281 and 288
Use the tapered sleeve which
is placed on the shaft when
fitting the oil pump. Otherwise
the seals will be damaged.
Eng, p 40-82 96-09-13, 10.3480
To Next Page
Loading...
