English – 51
Stop switch
Dismantling
Remove the earth screw (A) and cable (B).
Press the switch's securing tabs (C) towards
each other and push out the switch.
Cleaning and Inspection
Clean the switch and check its resistance as
follows:
Connect an ohm meter as shown in the fig.
The resistance should be:
In the stop position less than 0.1 ohm.
In the run position more than 1000 ohm.
Assembly
Fit the earth screw (A) and cable (B).
Note! On some models the earth cable should
be connected to the earth screw.
SAFETY EQUIPMENT
BC
A
Press the switch into the socket on the tank unit.
Eng, p 40-82 96-09-13, 10.1651
To Next Page
Loading...
