72 – English
Saw 394.
Dismantle the oil pump as follows:
1. Dismantle the screw (A) so that the
spring and latch pin (B) can be
removed.
2. Lever out the pump piston (C) with the
plastic plug (D) using a screwdriver.
3. Remove the seal (E).
A
B
CD
E
Saw 3120.
Undo the three bolts that hold
the oil pump and lift up the pump
by the cut-out for the adjuster
screw. Lift off the pump and
loosen the wire for manual oil
supply.
Dismantle the oil pump as follows:
1. Undo the screws (A) and remove the parts as
shown in the figure below.
2. Undo screw (B). NOTE! Left-hand thread.
BA
LUBRICATION SYSTEM
Eng, p 40-82 96-09-13, 10.3172
To Next Page
Loading...
