English – 105
TANK UNIT
Assembly
If a new fuel pipe is to be fitted proceed as
follows:
1. Measure the length of the old hose out-
side of the tank unit, note the length.
2. Oil half of the hose lightly and thread the
oiled part into the fuel tank from the outside.
3. Twist the hose so that it takes on the same
angle to the carburettor and let the hose
protrude as much as the old hose did.
4. Pull the hose through the filler hole using
tool 502 50 83-01, cut off the bevelled end
and fit the fuel filter.
Fit the throttle and lock.
Fit the engine sub-assembly to the tank unit
and at the same time insert the fuel pipe in
the bottom of the carburettor space.
If the saw has a throttle cable, insert this into
the carburettor space too.
NOTE!
Ensure that the fuel pipe and throttle
cable are not damaged.
Fit the bolts as set out in the table on the
previous page. Tightening torques, see the
service data for the saw in question.
The figures on the previous page illustrate all
types of mountings between the tank unit and
the engine sub-assembly marked by letters.
The mountings applying to the chain saw in
question is evident from the table on the next
page.
Make the handle heater connections if nec-
essary.
Connect the fuel pipe and the throttle cable to
the carburettor.
Fit the cylinder cover and the chain and bar.
Eng, p 83-124 96-09-13, 11.15105
To Next Page
Loading...
