English – 111
Assembly
PISTON AND CYLINDER
Oil the needle bearing and fit it into the
connecting rod little end.
Refit the piston with the arrow facing the
exhaust port.
Slide in the gudgeon pin and fit the circlip.
NOTE!
Ensure that no dirt or other foreign particles
fall into the crankcase.
Apply silicone rubber 504 98
26-01 to the lower crank-
case half’s contact surfaces.
Check that the seals fit in
their grooves correctly.
Tighten the crankcase
halves. Tightening torque
refer to ”Service data”.
Oil the piston and piston ring.
Compress the piston ring either by hand or
by using tool 502 50 70-01. Carefully fit
the cylinder.
Other saws
See continuation on next page.
Saws 36, 40, 41 and 45
Fit a new cylinder gasket
Saws 36 and 41
Eng, p 83-124 96-09-13, 12.56111
To Next Page
Loading...
