48 - English
6. MENU FUNCTIONS
6.4 Installation
The following operating settings are available via this
selection in the main menu.
• Guide width
to select the distance from the guide wire the
mower is allowed to travel when it follows this to
and from the charging station.
• Remote start 1
to control the robotic lawnmower so that it can
easier reach remote parts of the garden.
• Remote start 2
to control the robotic lawnmower so that it can
easier reach remote parts of the garden.
• Test settings
to check the above settings.
• Drive past wire
to set the distance over the boundary wire that the
mower should drive.
See 7. Garden examples for examples of garden
settings.
Guide width
The guide width is a measure of how far from the
guide wire the mower is allowed to travel when it
follows this to and from the charging station. The area
beside the wire which the mower then uses is called
the Corridor.
The robotic lawnmower has a default setting for
medium wide corridors. To further reduce the risk of
tracks forming, it is recommended to select a wide
corridor in working areas where it is possible to do so.
IMPORTANT INFORMATION
Always use as wide a guide width as
possible. The Narrow setting must only be
used when none of the other settings can be
used in the working area in question.
Guide width
Remote start 1
Remote start 2
Test settings
Drive past wire
Timer
Installation
Security
Settings
Guide width
Remote start 1
Remote start 2
Test settings
Drive past wire
Narrow
Medium
Wide
305_308,EN.book Page 48 Saturday, November 8, 2014 12:33 PM
To Next Page
Loading...
Need help?
General
