2
15
502 50 18-01
502 50 18-01
Electrical system
Dismantling
Model 326
Dismantle the starter, cylinder cover,
guard over the mu er and spark plug.
Unhook the throttle cable from the carbu-
rettor.
Dismantling
Model 326
The following components must be
dismantled for the ignition system to be
accessible.
The cylinder cover, starter, guard over the
mu er and spark plug.
Unhook the throttle cable from the carbu-
rettor.
NOTE!
Do not lose the rubber bushings tted between the starter and the fuel tank.
Remove the screws holding the clutch
cover.
Remove the clutch cover complete with
the shaft from the engine.
Remove the three screws holding the
clutch cover on the engine.
Lift o the cover together with the shaft.
NOTE!
Do not lose the rubber bushings tted between the fuel tank and the clutch
cover.
Loosen the short-circuit cable from the
ignition module.
Loosen both ends of the short-circuit cable
from the ignition module.
Dismantle the ignition module and the
centrifugal clutch.
Remove the remaining screws (A) holding
the ignition module and both screws (B)
that hold the centrifugal clutch.
Lift o the clutch, both support washers
and the ignition module.
To Next Page
Loading...
