●
●
●
●
NOTE: The grooves (slot) in the roll pins must
face upward toward the top of the casting as
shown.
Be sure the brake band spring has been greased,
and firmly press the spring cover into the nest
provided in the casting.
Install the bar, chain and clutch cover. NOTE:
Fire the brake to “center” the brake/clutch drum
before tightening the guide bar mounting nut and
rear fastener screw. Check the machanism 2-3
times through the “set” (full back) / “run” 1 “fire”
positions.
Set the brake and place the handguard in the
“run” position. Push the inertia weight forward;
upon release the weight must return to the rest
position. NOTE: When a force of 4.5-11 pounds
is applied to the upper part of the rear edge of the
weight, the chain brake must fire.
For Husqvarna Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com
To Next Page
Loading...
