. Remove the band tool. Lubricate the components
of the brake mechanism with oil or grease
Holding the handguard, position all the otht=
components against it.
Carefully insert the complete assembly as shown.
●
●
●
NOTE: Be sure the tang of the tension spring is
in place on the casting ledge.
Using the large and small diameter brake kit drift.
as pilot pins, center the brake mechanism and-
knee-link, position the small diameter roll pin with
the slot facing the top of the casting and tap into
place (flush with the face of the casting). NOTE:
Be sure the knee-link hole is centered by the
small diameter drift.
Position the large diameter roll pin (with the slot
facing the top of the clutch cover) and tap into
place flush with the casting face. To connect the
knee-link to the guide pin on the brake band, pull
back on the hand guard and insert the stamped
end of the brake band into the slot in the
knee-link. The roll pin will nest in the molded
notch in the elbow.
For Husqvarna Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com
To Next Page
Loading...
