Husqvarna 33 - Fuel and Lubrication; Fuel Mixing Ratios

-
Pull back on the brake tool to release tension on
the brake ring-tool.
Remove the ring-tool and
allow the brake band to return to the static
position. Remove the brake tool and drift.
Using a small diameter drift (through the access
hole on the outside of the clutch cover) tap out the
brake band anchor pin. Remove the brake band.
Check the brake band for wear. Replace the band
if worn to less than .020” thickness at the point of
heaviest wear. Clean and check all brake pads
for wear of damage.
Lubricate the brake spring with grease. Install the
brake band and spring. ~ NOTE: Position the
(band anchor) roll pin with the slot facing up in the
casting pocket, to ensure secure installation.
Using the brake tool to enlarge the band opening,
insert the ring-tool to retain the brake band.
For Husqvarna Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com