. Aliow the handguard to return to the “run” position
Remove the brake spring cover by prying up with
a screwdriver blade.
. Using the suitably sized drifts (supplied in the
brake repair kit) remove both the large and small
diameter roll pins.
. Insert the brake tool (as shown), using the lar9~.
diameter drift as a pivot pin in the clutch cover
mounting bolt hole.
.
c Position the notch in the brake tool against the roll
pin in the brake band.
For Husqvarna Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com
To Next Page
Loading...
