10
. Install the ignition
module/laminate assembly.
NOTE: Do not tighten the 3 mounting screws at
this time.
. Slide the (symmetrical) oil pump worm gear onto
the crankshaft and, using a tube-type aluminum
driver, tap the gear down to within .025” of the
crank case/seal face.
Apply grease to the worm
and pinion gears.
Install a new oil pump gasket
and fit the oil pump assembly into place.
Place
the long (upper) screw and short (lower) screw in
position and torque to spec. (see Section 2
Service Data).
. Insert the flywheel key and press to depth. NOTE:
The top of the key should be parallel to the center
axis of the crankshaft and not the taper.
● Carefully position the flywheel keyway over the
key and torque the flywheel nut to spec. (see
Section 2 Service Data). Using the plastic air gap
setting tool as a spacer, push the ignition module
against the flywheel and torque the 3 mounting
screws to spec. (see Section 2 Service Data).
For Husqvarna Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com
To Next Page
Loading...
