English – 39
TECHNICAL DATA
Recommended cutting equipment for Canada
The following is a list of recommended cutting equipment for chainsaws Husqvarna 543 XP and 543 XPG. The
combinations of powerhead, guide bar and saw chain meet all requirements outlined in the CSA Z62.1-11 Chainsaws
and Z62.3-11 Chainsaw Kickback standards.
The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the
corresponding maximum nose radius of a solid bar.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list.
For guide bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of
sprocket teeth may be considered to have equivalent kickback energy.
A hard nose bar having the same length and nose radius as a sprocket-nose bar may be considered to have equivalent
or less kickback energy than the sprocket-nose bar.
We recommend that you as replacement use the listed bars and chains or ”Type C Low-Kickback Saw Chains” which
are available at your dealer.
The following cutting attachments are approved for the models Husqvarna 543 XP and 543 XPG.
Note: For the chains above you are free to choose between 0.050" and 0.058" gauge drive link for the corresponding
bar, see the table below.
Saw chain filing and file gauges
Guide bar Saw chain
Length, inch Pitch, inch Gauge, inch Max. nose radius Type Drive link count
13
0.325 0.050 10T Husqvarna H30
56
15 64
16 66
18 72
13
0.325 0.058 10T Husqvarna H25
56
15 64
16 66
18 72
0.050"/1,3 mm H30 H22
0.058"/1,5 mm - H25
H1154914-49,543XP,543XPG,NA.fm Page 39 Thursday, December 18, 2014 8:54 AM
To Next Page
Loading...
