Husqvarna 576 XP/G AT - Replacing the Generator

24 – English
ELECTRICAL SYSTEM
Replacing the generator
1. The following components must be removed before
the generator can be replaced:
A. Starter. See page 18.
B. Flywheel. See page 20.
2. Remove the bolt for the rear damper element (D)
and upper AV spring (B). Remove the bolt on the
front AV element (D). See g. 10.
3. Dismantle the screw on the heater switch (A). See
g. 10.
4. Dismantle the throttle cable (A), impulse hose (B),
fuel hose (C), earth cable (D) and (E). See g. 11.
5. Dismantle the sleeve on the carburettor adjustment,
short-circuit cables (F) and (H). Loosen the cable (I)
on the carburettor heater. See g. 11.
Fig. 11
Fig. 10
I
G
H
F
C
D
B
A
E
C
A
D
B
A