Husqvarna 576 XP/G AT - Generator Replacement Steps

ELECTRICAL SYSTEM
English – 25
Replacing the switch
1. Remove the switch and disconnect the cables. See
g. 12.
2. Fit the cables on the new switch and press in the
switch.
Fig. 12
Fig. 14
Fig. 13
6. Dismantle the cables (A) and (B) on the heater
switch. Loosen connection (C). See g. 12.
7. Loosen the cable fastening on the tank. See g. 13.
8. Dismantle the screws (A) on the generator. See
g. 14.
Replacing the heating element in the tank unit
1. Remove the rear hand grip insert (A). See g. 15.
2. Remove the cable connections (C and B).
See g. 15.
3. Fit the heating element and cable connections.
Fig. 15
A
C
B
B
C
A
A