´®z+R?J¶6Q¨
Bar and chain combinations
The following recommended combinations of bar and saw chain are type approved for your chain saw.
Saw chain filing and file gauges
EC-declaration of conformity
(Applies to Europe only)
Husqvarna AB, SE-561 82 Huskvarna, Sweden, tel: +46-36-146500, declares under sole responsibility that the chain saws
Husqvarna 61, 268 and 272XP from 2005's serial numbers and onwards (the year is clearly stated in plain text on the type plate
with subsequent serial number), are in conformity with the requirements of the COUNCIL'S DIRECTIVES:
- of June 22, 1998 ”relating to machinery” 98/37/EC, annex IIA.
- of May 3, 1989 ”relating to electromagnetic compatibility” 89/336/EEC, and applicable supplements.
- of May 8, 2000 ”relating to the noise emissions in the environment” 2000/14/EC.
For information relating to noise emissions, see the chapter Technical data. The following standards have been applied:
EN ISO 12100-2:2003, CISPR 12:1997, EN ISO 11681-1:2004.
Notified body: 0404, SMP Svensk Maskinprovning AB, Fyrisborgsgatan 3, SE-754 50 Uppsala, Sweden, has carried out EC type
examination in accordance with the machinery directive’s (98/37/EC) article 8, point 2c. The certificates for EC type examination
in accordance with annex VI, have the numbers: 404/04/1045 - 61, 268, 404/06/1141 - 272XP/XPG.
In addition, SMP, Svensk Maskinprovning AB, Fyrisborgsgatan 3, SE-754 50 Uppsala, Sweden, has certified conformity with annex
V of the Council’s Directive of May 8, 2000 ”relating to the noise emissions in the environment” 2000/14/EC. The certificates have
the numbers: 01/161/063 - 61, 01/161/0064 - 268, 272XP/XPG.
The supplied chain saw conforms to the example that underwent EC type examination.
Huskvarna December 30, 2004
Bo Andréasson, Managing Director
Bar Chain
Length, inch Pitch, inch Gauge, mm Max. nose radius Type Length, drive links (no.)
15° 3/8 1,3 11T Husqvarna H42 56
16 3/8 1,3 11T 64
18 3/8 1,3 11T 66
20 3/8 1,3 11T 72
To Next Page
Loading...
