20 - English
3. INSTALLATION
Do not position the charging station so that the mower
can come closer than 3 metres behind the charging
station (for example on a narrow point). The mower
will not then find the charging station.
Installation and connecting the charging
station
1. Position the charging station in a suitable spot.
2. Attach the charging station to the ground using
the supplied screws.
3. Ensure the screws are secured all the way down
in the countersink.
4. Connect the low voltage cable to the charging
station.
Only use original cable and transformer.
5. Connect the low voltage cable to the transformer.
The connectors may be slightly difficult to
connect, as they are moisture-proof.
6. Connect the transformer’s power cord to a 230V
wall socket. It is preferable to use an earth-fault
breaker as recommended.
IMPORTANT INFORMATION
It is not permitted to make new holes in the
plate. Only the existing holes may be used to
secure the plate to the ground.
To Next Page
Loading...
