Why are mowing and charging times shorter than usual on my Husqvarna AUTOMOWER 220 AC?
If both the mowing and charging times are shorter than usual for your Husqvarna Lawn Mower, this is normal in high temperatures (gradually increasing above 25 °C). No action is required.
Why is my Husqvarna AUTOMOWER 220 AC giving uneven mowing results?
If your Husqvarna Lawn Mower displays 'Uneven mowing results', there could be several reasons. The mower might not be working enough hours per day, in that case increase the mowing time. The working area might be too large, so try limiting the area or extending the working time. Dull blades can also cause this, so replace the blades and screws. If the grass is too long, increase the cutting height and then successively lower it. If the mower works more at the top of a slope, change the Installation shape setting to Open. Also, check for grass accumulation by the blade disc or around the motor shaft, and remove any obstructions.
Why does my Husqvarna Lawn Mower have 'Low battery voltage'?
If your Husqvarna Lawn Mower displays 'Low battery voltage', it could be due to a few reasons. The mower may be unable to find the charging station, so adjust the search settings. You might also need to change the position of the charging station. Finally, the battery itself may be spent; its expected life is 1-4 years, so contact your dealer for a replacement.
Why is my Husqvarna Lawn Mower running but the blade disc not rotating?
If your Husqvarna Lawn Mower is running, but the blade disc isn't rotating, it's likely because the mower is searching for the charging station. No action is needed as the blade disc doesn't rotate during the search.
Why does my Husqvarna AUTOMOWER 220 AC Lawn Mower say 'Outside working area'?
If your Husqvarna Lawn Mower is showing 'Outside working area', it could be due to several reasons. Interference from metallic objects or buried cables in the area might be the cause, so try moving the boundary wire. Also, the working area might have too much slope, or the boundary wire might be routed incorrectly around an island or too close to the edge of the working area. To resolve this, ensure the boundary wire is routed correctly according to the installation instructions.
Why does my Husqvarna Lawn Mower show 'No contact in charging station'?
If your Husqvarna Lawn Mower has no contact in the charging station, it means that the mower is making poor contact with the contact strips in the charging station. Check that the mower has docked correctly in the charging station.
Why does my Husqvarna AUTOMOWER 220 AC have no drive?
If your Husqvarna Lawn Mower has no drive, it has likely got caught on something. Free the mower and rectify the reason for the lack of drive. If it is due to wet grass, wait until the lawn has dried before using the mower. To keep the drive wheels clean and thus increase traction, use Automower® wheel brushes.
Why does my Husqvarna AUTOMOWER 220 AC Lawn Mower have no contact in charging station?
If your Husqvarna Lawn Mower has no contact in the charging station, it means it makes poor contact with the contact strips in the charging station. Check that the mower has docked correctly in the charging station.
Why does my Husqvarna AUTOMOWER 220 AC Lawn Mower say 'No loop signal'?
If your Husqvarna Lawn Mower displays 'No loop signal', several factors could be at play. First, ensure the transformer is correctly connected to the mains and that the miniature circuit-breaker hasn't tripped. Reset it by disconnecting the power cord for 10 seconds, then reconnecting. Also, a broken boundary wire can cause this issue; check the LED on the charging station—a flashing light indicates damage, which you can repair with an original waterproof coupler. The problem might also stem from a lost connection between the mower and charging station; placing the mower in the station and resetting the PIN code via Settings - Security - PIN code may resolve this. Finally, confirm that the boundary wire is correctly routed, as incorrect routing around an 'island' can blank the signal. Inte...
Why does my Husqvarna AUTOMOWER 220 AC Lawn Mower have low battery voltage?
If your Husqvarna Lawn Mower displays 'Low battery voltage', it could be because it cannot find the charging station. You can try changing the search settings. Alternatively, the battery might be nearing the end of its life (1-4 years), in which case you should contact your dealer to replace it.
Provides essential safety guidelines for operating the Automower.
Explains capacity, mowing technique, and working method of the Automower.
Describes the three methods Automower uses to find the charging station.
Guidelines for the ideal positioning and installation of the charging station.
Explains how to install the boundary wire and its best positioning.
Step-by-step guide to connecting the boundary wire to the charging station.
Procedure for linking the Automower to the charging station and initial setup.
Explains when and how to install a guide wire for improved navigation.
Step-by-step instructions for starting the Automower.
Procedure for safely stopping the Automower.
Detailed instructions on how to clean the Automower.
Step-by-step guide on how to replace the Automower's blades.
Lists common fault messages, their causes, and recommended actions.
Describes common symptoms of Automower malfunction and their solutions.
General| Cutting Width | 22 cm |
|---|---|
| Cutting Height (min-max) | 20-60 mm |
| Battery Type | NiMH |
| Maximum Incline | 35% |
| Maximum Area Coverage | 1800 m² |
| Maximum Slope | 35% |
| Weather Resistance | Yes |
| Boundary Wire Required | Yes |
| Automower Connect | No |
| Working Area Capacity | 1800 m² |
| Blade Type | 3 pivoting blades |
To Next Page
