3023-029
3023-030
English - 83
TROUBLESHOOTING
In that case, move the connection for the new wire
closer to the disconnected end (roughly at the
middle of the suspected wire section) and check
again if the indicator lamp is green.
Continue until only a very short section of the wire
remains which is the difference between a ashing
blue light and a solid green light.
b) If the indicator lamp is solid green in test 3b)
above, a similar test is carried out but with the new
loop wire connected to AL instead.
5. When the break is found, the damaged section
must be replaced with a new wire. The damaged
section can be cut out if it is possible to shorten the
boundary wire. Always use original couplers.
3012-1323
OM_1157863-26_HQ 310,315,EN_160229.indd 83 2016-02-29 10:52:43
To Next Page
Loading...
