Husqvarna AUTOMOWER 315X - Page 15

Secondary
area
Main area
The Secondary area operating mode must be used as
the robotic lawnmower cannot travel on its own from the
secondary area to the charging station. See Operating
mode - Start on page 43 . In this mode, the robotic
lawnmower will never look for the charging station but
will mow until the battery runs out. When the battery is
flat, the robotic lawnmower will stop and the Needs
manual charging message will appear in the display.
Place the robotic lawnmower in the charging station to
charge the battery. If the main area has to be cut
straight after charging, the START button must be
pressed and the Main area selected before closing the
hatch.
3.5.3.2 Passages when mowing
Long and narrow passages and areas narrower than 1.5
- 2 m / 3.2 - 6.5 ft. should be avoided. It is then a risk
that the robotic lawnmower travels around in the
passage or area for a period of time. The lawn will then
look flattened. The narrowest possible passage for the
robotic lawnmower is 60 cm / 24 in (between boundary
wires).
Note: In passages narrower than 2 m / 6.5 ft. (between
boundary wires) Husqvarna recommends that a guide
wire is installed.
3.5.3.3 Slopes
The robotic lawnmower can operate in slopes. The
maximum gradient is defined as percentage units (%)
and is calculated as difference in elevation in
centimetres for every meter. Inside the working area the
robotic lawnmower can mow areas which slope up to
40%. Areas that slope more must be isolated with the
boundary wire.
The boundary wire can be laid across a slope that slants
less than 15%.
0-15%
0-15 cm / 0-6"
100 cm / 40"
The boundary wire should not be laid across a slope that
is steeper than 15%. There is a risk that the robotic
lawnmower will find it difficult to turn there. The robotic
lawnmower will then stop and the Outside working area
fault message is displayed. The risk is at its greatest in
damp weather conditions, as the wheels can slip on the
wet grass.
15- %
>15 cm / >6"
100 cm / 40"
However, the boundary wire can be laid across a slope
steeper than 15% if there is an obstacle that the robotic
lawnmower is allowed to collide with, for example, a
fence or a dense hedge.
When a part of the working area’s outer edge slopes
more than 15%, the boundary wire must be laid about
20 cm / 8 in. in on the flat ground before the beginning of
the slope.
840 - 001 - Installation - 15