How to fix a break in the boundary loop of my Husqvarna AUTOMOWER 440 Lawn Mower?
To fix a break in the boundary loop, find where the break is located. Replace the damaged section of the loop with a new loop wire, and splice it using an original coupler.
Why is my Husqvarna AUTOMOWER 440 charging station showing a red flashing light?
A red flashing light on your Husqvarna Lawn Mower charging station indicates an interruption in the charging station’s antenna. Unfortunately, I cannot provide specific troubleshooting steps for this issue. Please contact your local Husqvarna representative for assistance.
What to do if the Husqvarna Lawn Mower has a blue flashing light?
If your Husqvarna Lawn Mower is showing a blue flashing light, it could be due to a couple of reasons. First, the boundary loop might not be properly connected to the charging station. Make sure the boundary wire connectors are correctly fitted. Alternatively, there might be a break in the boundary loop. If so, locate the break, replace the damaged section with a new loop wire, and splice it using an original coupler.
How to find breaks in the loop wire of a Husqvarna AUTOMOWER 440?
If the loop wire of your Husqvarna Lawn Mower is broken, it's often due to unintentional physical damage, like accidentally cutting it while gardening, or stretching the wire too much during installation. To find the break, try halving the loop's distance where you suspect the damage. Keep halving the distance until you're left with a very short section of wire. This should help you pinpoint the location of the break.
Why is the light flashing blue on my Husqvarna Lawn Mower?
A blue flashing light indicates that the boundary loop is not connected to the charging station. Ensure that the boundary wire connectors are properly fitted to the charging station.
Why is the Husqvarna AUTOMOWER 440 Lawn Mower showing a blue flashing light?
If the Husqvarna Lawn Mower displays a blue flashing light, it typically indicates a problem with the boundary loop connection or a break in the loop. First, ensure the boundary wire connectors are correctly attached to the charging station. If the problem persists, there may be a break in the boundary loop. Locate the break, replace the damaged wire section with a new one, and securely splice it using an original coupler.
What to do if my Husqvarna AUTOMOWER 440 Lawn Mower displays a solid red light?
If your Husqvarna Lawn Mower shows a solid red light, this indicates a fault within the charging station's circuit board or an incorrect power supply. In this case, you should contact your local Husqvarna representative for assistance.
Why is my Husqvarna Lawn Mower showing a red flashing light?
If the Husqvarna Lawn Mower is displaying a red flashing light, it means there's an interruption in the charging station's antenna. Contact your local Husqvarna representative for assistance.
General| Cutting Width | 24 cm |
|---|---|
| Cutting Height Min | 20 mm |
| Cutting Height Max | 60 mm |
| Battery Type | Li-ion |
| Typical Mow Time on One Charge | 290 min |
| Sound Level | 56 dB(A) |
| Area Capacity | 4000 m² |
| Weather Resistance | Yes |
| Blade Type | Pivoting razor blades |
| Product Size | 72 × 56 × 31 cm |
To Next Page
